There are repair shops at our data center. We use them to quickly fix our miners and put them back to work.

We used to have a single repair shop, but that proved to be inconvenient — miner maintenance took longer. So we built another two workshops. They helped speed up and consolidate the whole process.

First, all miners go into the sorting room. They’re being unpacked, cleaned and made ready to go into the tech shop, where our staff check their condition.

👍 If everything is in order, performance tests are run to see if every chip and plate is functioning and if any bugs or viruses exist. Miners that pass the check-up get serial numbers. Our technicians send them over to the racks and bring them into operation.

👎 If any faults are detected, the miners in question are sent to the third repair shop, where they are put in order, tested again and sent to the racks at the main facility.

Do you enjoy reading about our data-center and what goes on in it? React to this post!

#minto_about

BZZZZZZZZ! Our buzzers say it’s meme time.

Leave your favorite memes in the comments, so the day after tomorrow we can pick the best one and reward the winner with 10 BTCMT tokens.

❗️Memes are accepted until 19 pm UTC this Friday.

Ready, set, hit send!

#minto_contest #minto_fun

Web 1.0, 2.0, and 3.0 — do you know the difference? How specific can you get? Take our quiz and test your knowledge.

#minto_education #minto_newbies